Resincoat High Build Epoxy Garage Floor Paint is a two-part epoxy resin...
Resincoat Industrial Factory Floor Paint is a heavy duty epoxy resin...
Resincoat Anti Slip Floor Paint is a heavy duty, epoxy resin floor...
High quality medium pile nylon roller for expert paint and sealer...
Resincoat Epoxy Crack Repair is an ultra strong, pourable epoxy resin...
Resincoat Damp Tolereant Epoxy Primer is suitable for use on concrete...
Resincoat Water Based Paint is a low viscosity solvent free epoxy resin...
Resincoat Epoxy Primer is a low viscosity solvent free epoxy primer used...
Follow the tree below to find the correct product for your concrete:
Use our colour guide here to choose which colour you would like to use. Please note that our colours shown are for guidance only. The appearance of the final product can vary due to varience in computer screen technology.
RAL # 7001
The substrate should be clean, free from laitance, oil, grease or other agents which may impair adhesion or drying. New concrete floors should be primed first with Resincoat Damp Proof Primer. Power floated floors should be Ground or blast-tracked. Open or porous substrates should be primed with Resincoat Deep Penetrating Primer. We recommend our associated hire services for renting surface preparation equipment. Click here to find a hire company local to you.
Do not mix until fully prepared.Keep the paint at room temperature. Mixing the base paint (Part A) before adding the hardener (Part B), can improve the flow of the paint on application. Pour the hardener (Part B) into the base (Part A), as there is enough room in the base tin to pour the hardener in for mixing. Thoroughly mix the base and hardener. An electric drill with stirrer attachment is recommended.Clamp the tin whilst mixing to save spillage. Ensure the paddle is moved to the side wall of the tin to mix all material.Once the base and hardener are mixed, use immediately.
Masking tape areas not to be painted. This will speed up ‘cutting in’. When mixed quickly cut in along the back wall with a paint brush, covering at least 60mm of the floor, and 2 metres down each side.Pour a line of paint across the floor a metre from the back wall. Use the Epoxy Roller (only use epoxy rollers as seen here) to spread the paint to the back wall and forward about a metre. Finishing with a roll in one direction.
The paint does not go on thick and needs to be worked to obtain good coverage. Coverage - 4-5m² / Kg depending on the porosity and texture of the surface. Pot Life - 10 minutes from mixing. Pay particular attention on warm days when the pot life will be shorter. Paint left in the tin will cure faster than paint spread onto the floor. Apply at the recommended coverage rate and in well ventilated conditions to give a good curing cycle.
Recoat within the full cure period.
At 20°C Re-coatable – 8 - 12 hrs or once surface has lost tackiness
Light traffic - 12 - 16 hrs
Full traffic - 24 - 36 hrs
Full chemical cure - Up to 7 days
Note: Lower ambient temperatures will results is slower curing times.
The ambient temperature of the area should not be allowed to fall below 10°C throughout the application and the curing period. The surface temperature must be above 5°C. Where possible it is recommended that the application area is heated (do not use gas heaters, these form moisture in the air which will react with the Epoxy.) to a minimum temperature of 15°C to allow the ambient and substrate temperature to stabilise prior to installation.All figures are approximations at 20°C given as a guide and dependent on variables such as temperature, humidity, air circulation, etc.
Finally, please ensure you order enough paint for the job as shades can sometimes vary slightly between batches.