Independently tested, our antimicrobial wall coating guarantees fast, effective antimicrobial protection for the effective lifetime, helping to keep your surroundings hygienic and reducing the risk of cross-contamination. An antibacterial coating specifically prevents the growth of bacteria whilst our antimicrobial coating goes further than this destroying the growth of bacteria as well as a wide range of microbes such as fungi and mould. The epoxy coating will provide complete protection minimising staining and bad odours as well as being easy to clean & maintain. We proudly manufacture all our epoxy resin products in the UK for guaranteed quality and performance. Resincoat epoxy resin is 5x thicker than cheaper alternatives offering a high durable design.

How does Resincoat Antibacterial Wall Coating kill bacteria?

The below diagram demonstrates how the antibacterial technology prevents the growth of bacteria on a floor coated with Resincoat antibacterial wall coating.




Please see below for coverage rates. If you are coating a large area and would like expert advice, please call our team who will be happy to assist you.

2.5kg: up to 15m²

5kg: up to 30m²

Please note: the above coverage rates are per coat, in most cases we advise 2 coats.




Old paint finishes should be removed if flaking at all and the surface should be sanded to create a texture (also known as a mechanical key) prior to applying Resincoat Antibacterial Wall Coating. After the surface has been completely abraded, thoroughly sweep and vacuum the area of any remaining dust or contaminants. For more information on preparation, please see technical data sheet. 



We advise when applying this product the ambient temperature is at least 7°C.

1. Mix Part A on its own with a mixing paddle attached to an electric drill for about 1 minute before adding ALL of Part B and continue to mix for another 90 seconds, keeping the paddle in suspension to avoid mixing air into the unit.

2. Pour entirety of the tin's contents into a plastic paint scuttle or tray.

3. Immediately begin applying your paint with a nylon-bonded resin suitable roller.

4. Use a brush around the edges to cut in (a second pair of hands can be useful for this stage).

5. As soon as the first coat has started curing (is no longer tacky to touch) you can re-coat; this should take 12-24 hours.

6. The cured final coat is ok for contact however chemicals, including water/cleaning substances, should not be introduced for the first 7 days (Full chemical cure).


PLEASE NOTE: The pot life of this product is 40 minutes. This means that once parts have been mixed, the paint will start to chemically cure after this time. Ensure you remove the paint from the tin in this window. The paint will then be workable on your floor for up to 60 minutes. 

Pot life = Time to harden in pot following addition of hardener

Working Time = Time to apply product before it becomes unworkable



Roller sleeves should be used once per coat, two coats will require two roller sleeves.

This product should NOT be split. Taking smaller quantities from each tin, even if measured correctly, may cause issues with activating.


Data sheet

Professional, High Gloss Finish
Water-Based Paint With Antimicrobial Properties
Bare Concrete, Wood, Screeds, Steel
Product Components
Resin (Part A) + Activator (Part B)
Typical Installations
Anywhere Requiring Antimicrobial Surfaces, or places with hygiene and Infection Control
Solvent Content
Solvent Free
Re-coat/Foot-traffic Time (at 20°C)
4-6 Hours
Drying Time (at 20°C)
24 Hours
Pot Life
The Pot Life Of This Product Is 40-60 Minutes
Application Tools
Epoxy Roller Sleeve and Frame, Brush

Specific References



Antibacterial Wall Coating TDS

Download (440.73KB)

Colour Chart

Download (129.88KB)

Frequently Bought Together

6 other products in the same category:

Comments (1)