High Performance One-Pack Line Marking Paint

This versatile marking paint is supplied as a one-pack product meaning no additional mixing or other parts are required. Our formula is easy to use and quick drying times make it ideal for both DIY & industrial users ensuring projects are completed in a timely manner with little down time.

Resincoat reflective road marking paint is primarily designed for application of general road markings such as zebra crossings, parking bays, road markings, runways and more. This paint however is not restricted to traffic signals and cycle lanes it is often used on pavements, parking spaces and in some cases sports and athletic facilities. Resincoat Reflective Road Marker Paint is also commonly used as a durable alternative to thermoplastic road markings when machinery access is limited. Such environments usually include factory floors, school playgrounds and multi-story car parks.



Please see below for coverage rates. If you are coating a large area and would like expert advice, please call our team who will be happy to assist you.

5 Litres in m²: 60m²

5 Litres in linear metres: 600m at a width of 10cm

Please note: the above coverage rates are per coat, in most cases we advise 2 coats.




We would recommend removing traces of existing lines before applying this paint, especially if it is flaky, as this will negatively impact adhesion of the paint to the surface. Any cracks, damage or defects in the concrete should be made good using repair compounds. Once dried, it will be necessary to clean and then lightly abrade the existing lines and apply Resincoat Car Park Line Marking Paint directly over the top. Ensure that the concrete is clean and free from dust, laitance, oil etc. A wire brush is generally sufficient to lift and clear debris. The loose debris and material must be vacuumed away after brushing or sanding. 



Brush/Roller application:

1. Stir the paint thoroughly before use.

2. Apply your first coat evenly with roller in a cross-rolled fashion.  

3.Protect from the elements and leave to dry for 12 hours.

4. Apply your second coat (two coats are recommended) and leave to dry completely before use.



Roller sleeves should be used once per coat, two coats will require two roller sleeves.

This product should NOT be split. Taking smaller quantities from each tin, even if measured correctly, may cause issues with activating.

This product is NOT self levelling.


Data sheet

Finely Textured Reflective Coloured Finish
Solvent Based Chlorinated Rubber
Concretes, Asphalt, Etc
Product Components
One-Pack System
Typical Installations
Floor Markings On Roads, Car Parks, Warehouses, Airport Runways, School Yards, Etc
Re-coat/Foot-traffic Time (at 20°C)
12 Hours
Drying Time (at 20°C)
4 Hours
Application Tools
Roller, Brush, Pad

Specific References



Reflective Line Marker TDS

Download (370.23KB)

Frequently Bought Together

3 other products in the same category:

Comments (1)