DESCRIPTION

Resincoat Weatherguard Extreme Paint (Clear) is a polyaspartic paint option which cures rapidly and offers excellent protection and resistance to numerous high traffic conditions. This paint offers a tough, quick and stylish solution to your flooring needs. Providing a tough, gloss, fast-curing coating in a clear finish. Typical applications include walls and exterior areas which require UV Stable coating.

 

COVERAGE RATES

Please see below for coverage rates. If you are coating a large area and would like expert advice, please call our team who will be happy to assist you.

2.5kg: up to 20m²

5kg: 35-40m²

Please note: the above coverage rates are per coat, in most cases we advise 2 coats and is dependant on the porosity of the surface.

 

APPLICATION GUIDE

Preparation

Old paint finishes should be removed if flaking at all and the surface should be sanded to create a texture (also known as a mechanical key) prior to applying Resincoat Weatherguard Paint. After the surface has been completely abraded, thoroughly sweep and vacuum the area of any remaining dust or contaminants before applying a suitable primer. For more information on preparation, please see technical data sheet. 

 

Application

As Resincoat Weatherguard Extreme (Clear) is a polyaspartic paint, it can be applied in temperatures as low as -5°C.

1. Mix Part A on its own with a mixing paddle, attached to an electric drill, for about 1 minute. Once mixed, add ALL of Part B and continue to mix for another 90 seconds, keeping the paddle in suspension to avoid mixing air into the unit.

2. Pour entirety of the tin's contents into a plastic paint scuttle or tray.

3. Immediately begin applying your paint with a nylon-bonded resin suitable roller.

4. Use a brush around the edges to cut in (a second pair of hands can be useful for this stage).

5. As soon as the first coat has started curing (is no longer tacky to touch) you can re-coat; this typically takes 2 hours at 10°C, however curing times does increase in sub-zero temperatures.

6. The cured final coat is ok for contact. Chemicals, including water, should not be introduced for the first 2 days (Full chemical cure) if at all possible.

 

PLEASE NOTE: The pot life of this product is 30 minutes at 25°C. This means that once parts have been mixed, the paint will start to chemically cure after this time. Ensure you remove the paint from the tin in this window. The paint will then be workable on your floor for up to 40 minutes. 

Pot life = Time to harden in pot following addition of hardener

Working Time = Time to apply product before it becomes unworkable

 

USEFUL INFORMATION

Roller sleeves should be used once per coat, two coats will require two roller sleeves.

This product should NOT be split. Taking smaller quantities from each tin, even if measured correctly, may cause issues with activating.

EWP012

Data sheet

Appearance
Smooth, Gloss Finish
Composition
Clear, Polyaspartic, Low Viscosity
Substrates
Concrete, Wood And Cementitious Walls
Product Components
Resin (Part A) + Activator (Part B)
Typical Installations
Any stonework of external buildings
Re-coat/Foot-traffic Time (at 20°C)
60 Minutes (Can be applied at -5°C, but this increases the cure time)
Drying Time (at 20°C)
12 Hours (Can be applied at -5°C, but this increases the cure time)
Pot Life
The Pot Life Of This Product Is 30 Minutes at 25°C
Application Tools
Roller, Brushes

Specific References

ean13
5056489405947
upc
500045234632

Download

Weatherguard Extreme (Clear) TDS

Download (441.77KB)

5 other products in the same category:

Comments (0)